Harley Davidson Battery Tender Instructions

8-12 hours This waterproof fully-automatic charger is ideal for both short term and seasonal storage even if moisture sneaks into your storage area.

Harley davidson battery tender instructions. Apply a light coating of Harley-Davidson electrical contact lubricant Part Number 99861-02 petroleum jelly or other corrosion retardant material to the battery terminals cable connectors Battery Charging Harness ring terminals and connector located under the weathershield cap. Use a large screwdriver to remove the bolt. When the battery has finished charging the Battery Tender will automatically switch to maintenance mode thus ensuring the battery will not go dead once again.

Battery tenders are not meant to charge a dead. Rings or clamps are hooked up backwards. Got new battery tender and still blinking red light.

Set up the AC and DC power cords for the Battery Tender so that they will not get caught in any moving parts of the vehicle. Verify whether the vehicle has a positive or negative ground system. Motorcycle Chargers for Long Life.

Here is how to install a Battery Tender Junior battery charger on a The instructions on my tender jr. Battery voltage is less than 3 volts. Harley-Davidson 800ma Waterproof Battery Tender.

The basic Battery Tender will recharge a battery at a rate of 75 ampshour. If the cord wont reach you may need to use an extension cord. Davidson Follow the instructions in your Owners Manual to remove the seat.

These are especially helpful if you are not riding your bike every day. The exact time will vary. A 12 volt battery may not recover from a discharge this deep Disconnect all loads from battery or battery from vehicle then reattach Battery Tender PLUS.